toggle quoted messageShow quoted text
I'll investigate on the vin/gnd battery. I also have the flyswatter, but I remember having trouble with flashing with it, so I sticked with the FTDI but will check that out too. Eventually, I would want the board to run the application on power up, so it would require no connection with my computer at all. Zephyr, being a IoT OS, must have this capability. Let me know if anyone else knows how to by pass the need of usb.
On Tue, Nov 14, 2017 at 1:27 PM, Rosen, Michael R <michael.r.rosen@...>
Curie boards generally flash in one of two ways: over JTAG or over USB. In typical uses, they actually flash over the Curie USB interface (using the USB DFU protocol;
via dfu-util). That’s why you need USB connected in order to flash the device. Not sure how easy it is to do JTAG flashing on tinyTILE though, it requires a flyswatter2 or similar device for Arduino 101.
Not 100% sure of this, but you should be able to connect a battery to the VIN/GND holes of the tinyTILE and leave the USB open for flashing. If you intend to
use a USB Battery, then you are somewhat stuck; though there might be ways to do OTA updates using the BLE Radio SoC if you are interested in investigating that…
Also note that on boot, there might be a UART flashing mechanism on boot, but I really haven’t done anything with it before and its really an afterthought to
the main USB or JTAG mechanisms. It uses the XModem protocol and I think you will likely have to make a script specifically for handling it. But if your needs really merit it, it might be worth the effort. This feature may or may not be there on the default
Code for the bootloader(s) that run on tinyTILE (or at least a close version to the one on tinyTILE) can be found here:
I'm flashing my tinyTILE using DFU over FTDI cable. My computer, that has the zephyr applications, is connected to tinyTILE via a FTDI cable as TX & RX and a usb cable as power to the tinyTILE. It flashes fine;
however, when I power the board externally so that my computer and tinyTILE is only connected with the FTDI cable, the application will not flash. I was always under the impression that the usb cable only functions as a power source, but it seems to be more
than that. Only when the board is connected both by the FTDI and the USB cable will the zephyr application flash to my board. This means I won't be able to flash my zephyr application using battery power which defeats the purpose an IoT OS. I've tried the
same with the arduino 101 board and it still does the same thing (wouldn't flash). I must be missing something. Wondering if anyone knows what I'm doing wrong.