Jiří Kubias <jiri.kubias@...>
toggle quoted messageShow quoted text
I measuring the time via oscilloscope - then the time measurement is independent on zephyr time. The printk is just for info.
Welcome to awesome zephyr community.
Im new to Zephyr and Im trying to measure the GPIO handler latency. I have modified the samples/basic/button example to toggle LED pin when the handler rises. The test is to measure the time between input pin change and output pin change. I have measured maximal value about 3us and typical about 2.6us. The processor is SAME70 @ 300MHz so 3us is 900 instructions - why it took so long? It should be in tenth of ns. Do I have correct approach or am I doing something wrong? I have checked the sensor drivers and they are using the same workflow.
The handler code is
void button_pressed(struct device *gpiob, struct gpio_callback *cb, u32_t pins)
gpio_pin_write(dev, LED, cnt % 2);
printk("Button pressed at %d\n", k_cycle_get_32());
k_cycle_get_32() prints cycles.
Ing. Jiri Kubias
mobile: 775 593 956