On Thu, Oct 11, 2018 at 04:01:05PM -0700, cpmcparland@... wrote:
I need to get a sensor data stream flowing from a BT network into a linux
host. Have tried
to setup BT HCI interface but no luck getting hci0 interface to move from
DOWN to UP.
So, thought I would take a different approach and put a dual stack on the
nrf52 with the
ip link to the host going through a serial port.
BTW, if you have USB you can enable Ethernet over USB and connect to
So, I would like to set up a slip tcp/ip connection between a linux host
and a nrf52840. I know
slip can be used to connect to a qemu simulation. Has anyone used slip to
talk to a physical
uart interface? If so, can I use the nrf52840's console port or do I need
to use a seperate
uart and interface via a FTDI usb cable?
Echo_server sample code seems to be a good base to start with....Any
suggestions would help.