On Thu, Oct 11, 2018 at 04:01:05PM -0700, cpmcparland@rtisys.org wrote:
Hi,
I need to get a sensor data stream flowing from a BT network into a linux host. Have tried to setup BT HCI interface but no luck getting hci0 interface to move from DOWN to UP. So, thought I would take a different approach and put a dual stack on the nrf52 with the ip link to the host going through a serial port.
BTW, if you have USB you can enable Ethernet over USB and connect to your PC.
Best regards Andrei Emeltchenko
So, I would like to set up a slip tcp/ip connection between a linux host and a nrf52840. I know slip can be used to connect to a qemu simulation. Has anyone used slip to talk to a physical uart interface? If so, can I use the nrf52840's console port or do I need to use a seperate uart and interface via a FTDI usb cable?
Echo_server sample code seems to be a good base to start with....Any suggestions would help.
