Re: Slip TCP connection between linux host and nrf52840


Andrei
 

Hi

On Thu, Oct 11, 2018 at 04:01:05PM -0700, cpmcparland@rtisys.org wrote:
Hi,

I need to get a sensor data stream flowing from a BT network into a linux
host.  Have tried
to setup BT HCI interface but no luck getting hci0 interface to move from
DOWN to UP.
So, thought I would take a different approach and put a dual stack on the
nrf52 with the
ip link to the host going through a serial port.
BTW, if you have USB you can enable Ethernet over USB and connect to
your PC.

Best regards
Andrei Emeltchenko


So, I would like to set up a slip tcp/ip connection between a linux host
and a nrf52840.  I know
slip can be used to connect to a qemu simulation.  Has anyone used slip to
talk to a physical
uart interface?  If so, can I use the nrf52840's console port or do I need
to use a seperate
uart and interface via a FTDI usb cable?

Echo_server sample code seems to be a good base to start with....Any
suggestions would help.

Regards,
Chuck McP

Join devel@lists.zephyrproject.org to automatically receive all group messages.