Tommy Lin (林志聰) <Tommy.Lin@...>
We have a product using nRF51824 with Zephyr v1.13.0.
Our DUT connect with RF equipment.
Step1: DUT enter Rx mode with HCI command.
Step2: RF equipment send 1500 bytes with -86dbm.
Step3: DUT end Rx mode
After then , DUT will show “tx time out “ error message.
1. If RF equipment send a dbm below -86 , the error message will disappear.
2. We use Zephyr v1.13.0 and v1.14.0 , and the result is the same.
Could you give us some suggestions?