Re: Getting Started Guide
Tommy Lin (林志聰) <Tommy.Lin@...>
Sorry, I have attached btmon log to Attachment.
I have found a similar problem as following:
following up above link , I don’t set the static address manually , but it show an abnormal behavior after auto-power
root@localhost:~# btattach -B /dev/serial/by-id/usb-FTDI_Quad_RS232-HS-if01-port0 -S 1000000 -P h4 &
Attaching Primary controller to /dev/serial/by-id/usb-FTDI_Quad_RS232-HS-if01-port0
root@localhost:~# Switched line discipline from 0 to 15
Device index 0 attached
root@localhost:~# btmgmt --index 0
Waiting for index 0 to appear
Can Zephyr Kernel: 2.2.0 support nRF51 chip ?
From: Boie, Andrew P <andrew.p.boie@...>
Sent: Friday, February 14, 2020 3:44 AM
To: Tommy Lin (林志聰) <Tommy.Lin@...>; Cufi, Carles <Carles.Cufi@...>; zephyr-devel@...
Cc: devel@...; Isaac Chen (陳尚航) <Isaac_Chen@...>
Subject: RE: [Zephyr-devel] Getting Started Guide
when reporting issues, either here or in GitHub, can you copy/paste your terminal output instead of posting screen shots?
Thanks for your suggestion.
Now, I can download code and build it successfully.
When I burn zephyr.hex into our chip (NRF51824) , and I encounter an issue.
In my previous version (kernel: 1.13 SDK: 0.9.5) , the issue is absence .
Could you give us some suggestions.
Zephyr requires Python 3.6 or later, and from your log you seem to be using Python 3.5.
Please update your Python installation. If you are on Ubuntu something like this should work:
sudo apt install python3.7
sudo update-alternatives --config python3
I following Getting Started Guide .
In ‘west update’ , I encounter an error:
My PC is Ubuntu 16.04 LTS
Could you give us some suggestions