On 18. Feb 2020, at 11.29, Mayank <@mayank_patel> wrote:
I have a doubt regarding one of the sample application of zephyr (samples/bluetooth/hci_uart).You might get lucky with disabling hardware flow control, however this standard HCI transport officially requires it (see Vol 4, Part A section 3 in Bluetooth Core Specification 5.2).
Q2: Can i implement software flow control in hci_uart application ? If yes then how?Yes, but it should be its own application rather than an extension of samples/bluetooth/hci_uart. The standard HCI transport for UART in the situation where you don’t have hardware flow control available is is called the Three-wire UART transport protocol and you can find it in Vol 4, Part D of the Bluetooth Core Specification 5.2. We don't currently have a sample application for this, but a contribution would be very welcome. We do have an HCI driver in drivers/bluetooth/hci/h5.c, but that’s the host side implementation of this transport (you’re interested in the controller side).
Q3: What is the meaning of this flag in zephyr confiuration : CONFIG_BT_HCI_ACL_FLOW_CONTROL?I don’t think I can explain it any better than its Kconfig documentation (please read it if you haven’t!), but it’s not something that’s directly relevant for you regarding the UART setup, since ACL flow control is a higher level construct. Since you’re doing a controller-only build you may want to enable it (the host can then later choose if it wants to use it or not), but this is not going to help you with the HCI transport situation.