1. Messages
  2. hci interface stopped working after few hours

Re: hci interface stopped working after few hours #ble #hci #nrf52480 #uart

Carles Cufi
 

Hi  Mayank,

 

When you create the GitHub issue please be specific about the exact layout of the setup you have.

It is not fully clear to me if you are connecting the nrf52840_pca10056 to the i.MX6UL via the PCA10056’s USB connector (i.e. using the PCA’s on-board debugger) or directly via lines to the UART from the i.MX’s pins to the nRF52840’s pins without any circuitry.

 

Thanks,

 

Carles

 

From: devel@... <devel@...> On Behalf Of Mayank via Lists.Zephyrproject.Org
Sent: 06 March 2020 11:24
To: devel@...
Cc: devel@...
Subject: Re: [Zephyr-devel] hci interface stopped working after few hours #ble #hci #nrf52480 #uart

 

Hi All,

Here i'm facing the issue even after using the full UART (Tx, Rx, RTS, CTS).
These 4 pins are connected & configured from both (i.MX6UL & nrf52840_pca10056).

Note : nrf52840 chip is flashed with HCI_UART sample app of zephyr. In that i have configured 4 pins and make HWFC enable from nrf5.conf file.

Ans still i'm not facing this issue continuously. Lets say i'm keeping beacon scanning on for 4-5 hours then its working fine. It crashes when i keep it running for 2-3 days.

Thanks,
Mayank

Join {devel@lists.zephyrproject.org to automatically receive all group messages.