Topics

Regarding zephyr application development


Keya Shah <keyashah24@...>
 

Hi there,

I would like to boot the image of a zephyr application on the galileo board
gen 2. For this purpose I am have followed the instructions to create the
bootable image and copied it to the usb drive.
Also I have connected the usb to the board, and used a usb to microusb
cable to connect my laptop to the board. However, when I power on the
board, the terminal on putty does not show anything.
Could you please help me with this? How can I successfully load the image
on the board.

Regards,
Keya Shah


Flavio Santes <flavio.santes@...>
 

Hello,

Please read carefully:
(1) http://www.intel.com/content/www/us/en/embedded/products/galileo/galileo-g2-datasheet.html
(2) https://software.intel.com/en-us/articles/intel-galileo-gen-2-board-assembly-using-eclipse-and-intel-xdk-iot-edition

In (2) you are going to find how to open a terminal to the Galileo Gen 2 from Windows OS.

After that, take a look at the section "Booting the Galileo Board" here:
(3) https://www.zephyrproject.org/doc/board/galileo.html

Hope this helps