Topics

Timeout in NCS (nRF Connect SDK) by Nordic Semiconductors using Zephyr OS


Lavingia, Raj
 

Hello,

 

I am using the default Zephyr BLE stack while using the NCS SDK with nrf52840 development board by Nordic.

 

My setup is as follows

Board1 – Running a Peripheral_Uart demo code which is advertising.

Board2 – Running a Central_Uart demo code which is scanning.

 

When the scan starts on board 2, I am filling the advertising address of the devices which are advertising, in a buffer. When I started the printing the buffer, the addresses repeat at a certain time period. For example, if I see 01:01:01:01:01:01 address at time X sec, I see the same address at X + (120-180)sec again. So I am wondering if the data coming from the callback is getting refreshed at a certain time interval? If so, which parameters are controlling this refresh rate? Is it possible to change this time which is 120-180 sec approximately right now to whatever value I want?

 

Thanks

Raj Lavingia I Embedded Software Engineer

Shure Incoporated

5800 W. Touhy Avenue

Niles, Illinois 60714-4608 USA

T +1.847.600.6276

shure.com

 




This e-mail message (including any attachments) contains confidential, non-public information. It also may be protected by the attorney/client or other applicable privileges. It is intended to be communicated only to the designated recipient(s). Unauthorized use, reproduction, dissemination, or communication of this message or any information contained in this message is strictly prohibited and may be unlawful. If you are not an intended recipient of this message, please notify the sender promptly by e-mail or contact Shure Incorporated at info@... or 800-25-SHURE (800-257-4873).