OK, I finally was able to catch the fault while I had a serial console connected and here’s what I saw:
toggle quoted messageShow quoted text
***** HARD FAULT *****
Executing thread ID (thread): 0x20001908
Faulting instruction address: 0xbc76
What do I do with that info? Is there a way to determine what code corresponds to that address?
On Aug 22, 2017, at 3:27 PM, Chettimada, Vinayak Kariappa <firstname.lastname@example.org> wrote:
I can help you if its an issue with BLE, can you give details of the application you are using and the symptoms of the issue?
I wrote into the list about an issue I was having with an NRF51822 board a couple days ago. It’s occasionally ending up in _SysFatalErrorHandler but I’m still not sure why (though I suspect it may be something BLE related).
I’m trying to attach a debugger with the ultimate goal of printing a stack trace when the code ends up in the error handler. First I’m starting an OpenOCD server:I have no experience myself with OpenOCD, I always have used our DK boards with JLinkGDBServer or pyocd-gdbserver (mbed debugger host firmware).
$ openocd -f interface/stlink-v2.cfg -f target/nrf51.cfg
And then trying to connect GDB:
$ arm-none-eabi-gdb outdir/nrf51_blenano/zephyr.elf
(gdb) set verbose on
(gdb) target remote localhost:3333
Remote debugging using localhost:3333
warning: platform-specific solib_create_inferior_hook did not load initial shared libraries.
Reading in symbols for /Users/scott/Code/bms/zephyr/lib/libc/minimal/source/stdout/fprintf.c...done.
fprintf (F=<optimized out>, Abort trap: 6
The OpenOCD logs show:
accepting 'gdb' connection on tcp/3333
dropped 'gdb' connection
Any idea why I’m getting this error? I’m new to OpenOCD and GDB so I’m not sure if this is an issue with my toolchain setup or if it is something related to Zephyr. Any help would be much appreciated!
Zephyr-users mailing list