Determining source of GPIO Interrupt on NRF52832 #nrf52832 #gpio

bbradley@...
 

Hello, 

I hope I am posting this question in the correct place.

I have an interrupt handler which can be configured to trigger on either edge. This is working perfectly, but I want to perform a different action on a rising edge vs a falling edge in some cases. Is there any way to do this? (i.e., perhaps I can determine in the interrupt context that a rising edge and not a falling edge was triggered?)

I am configuring the interrupts and registering the handler using the gpio API (gpio_pin_configure, gpio_init_callback, gpio_add_callback, gpio_pin_enable_callback), but the interrupt handler will act differently on a rising edge vs falling edge, for instance, so it is helpful to know which specific flags were raised that triggered the interrupt. I am currently using the gpio_pin_read API to work around this, but I am not sure if this is the best solution.

In other MCU's there is often an API to read the status register containing the interrupt flags that have been raised, and then an API for clearing the status register after reading. Is there anything similar with Zephyr? Or perhaps there is a way to have two different handlers for rising edge/falling edge?

I am using Zephyr v2.0.99 right now.

Thanks for any help, 
Brian

Join users@lists.zephyrproject.org to automatically receive all group messages.