Hello,

I have used the following overlay:

/ {
     soc {
         timers1: timers@40010000 {
             status = "okay";

             pwm {
                 status = "okay";
             };
         };

         timers2: timers@40000000 {
             status = "okay";

             pwm {
                 status = "okay";
             };
         };

         timers3: timers@40000400 {
             status = "okay";

             pwm {
                 status = "okay";
             };
         };

         timers4: timers@40000800 {
             status = "okay";

             pwm {
                 status = "okay";
             };
         };
     };
};

The prj.conf file contains the following regarding PWM:

CONFIG_PWM=y
CONFIG_PWM_STM32=y

I used the following code to test:

     auto dev_pwm = device_get_binding("PWM_1");

     if (dev_pwm != nullptr)
     {
         LOG_INF("Have PWM device.");

         int ret = pwm_pin_set_usec(dev_pwm, 1, 100, 50, 0);

         if (ret != 0)
         {
             LOG_ERR("Could not set PWM.");
         }
         else
         {
             LOG_INF("PWM set.");
         }
     }

The output:

[00:00:00.006,000] <inf> main: Have PWM device.
[00:00:00.006,000] <inf> main: PWM set.

I am measuring pin D7 on the board (PA8 for the chip), and no pulse.

Florian

Op 12/11/2020 om 08:36 schreef Adam Podogrocki:
> Hi Florian,
>
> have you set /status/ of the appropriate Timer & PWM device to "okay"?
> Have you activated the PWM driver in Zephyr Menu Config? Have you
> successfully got device binding in the source code?
>
> Cheers,
> Adam
>
> On Thu, 12 Nov 2020 at 01:54, Florian Hester via
> lists.zephyrproject.org <http://lists.zephyrproject.org>
> <florian=celaeno.org@...
> <mailto:celaeno.org@...>> wrote:
>
>     Hello,
>
>     When i look at the documentation of the Nucleo F411RE board at:
>
>     https://docs.zephyrproject.org/latest/boards/arm/nucleo_f411re/doc/index.html
>     <https://docs.zephyrproject.org/latest/boards/arm/nucleo_f411re/doc/index.html>
>
>     I can see PWM as a supported feature. However,  the board YAML file
>     (boards/arm/nucleo_f411re.yml) does not list PWM as supported and the
>     board DTS (boards/arm/nucleo_f411re/nucleo_f411re.dts) does not
>     enable
>     any PWM device present on the hardware.
>
>     I've tried using an overlay to enable it anyway (the timers and the
>     pwms), this compiles successfully and flashes (via JLink)
>     successfully,
>     but using the PWM API (or the shell pwm commands) does not appear to
>     have any effect (no output pulse).
>
>     I have tried the PWM functionality in ARM mbed, where it works.
>
>     Why does Zephyr not have support for PWM on this board?
>
>
>     Florian
>
>
>
>
>
>     
>
>