Re: I2C driver for nrf52840 not being compiled

Chettimada, Vinayak Kariappa

Hi Ashish,

Did you select CONFIG_I2C_NRF5 in menuconfig or set CONFIG_I2C_NRF5=y in prj.conf file?



On 15 Dec 2017, at 05:56, wrote:

Hello everyone !

I'm trying to interface an I2C device with nrf52840 controller.

When I look into ../zephyr/drivers/i2c directory, there is no Kconfig file corresponding to i2c_nrf5.c

Again in Kconfig, this driver isn't included, consequently I'm not being able to compile ../zephyr/samples/drivers/i2c_fujitsu_fram demo for nrf52840.

what needs to be done to fix this issue?

Warm regards,
Ashish Shukla
Jr. Embedded Engineer
Research & Development

Please consider the environment before printing this e-mail or its attachments.

Disclaimer: The information contained herein (including any accompanying documents) is confidential and is intended solely for the addressee(s). If you have erroneously received this message, please immediately delete it and notify the sender. Also, if you are not the intended recipient, you are hereby notified that any disclosure, copying, distribution or taking any action in reliance on the contents of this message or any accompanying document is strictly prohibited and is unlawful. The organization is not responsible for any damage caused by a virus or alteration of the e-mail by a third party or otherwise. The contents of this message may not necessarily represent the views or policies of Corvi

Zephyr-users mailing list

Join to automatically receive all group messages.