Hello everyone !!!
I'm working with custom PCB of nrf52840. I need to set VDD voltage which is also GPIO high level voltage equals to 3.3V, otherwise it's 1.8V by default.
How can I configure this?
How can I access registers of nrf52840 in zephyr architecture?
Jr. Embedded Engineer
Research & Development
Please consider the environment before printing this e-mail or its attachments.
Disclaimer: The information contained herein (including any accompanying documents) is confidential and is intended solely for the addressee(s). If you have erroneously received this message, please immediately delete it and notify the sender. Also, if you are not the intended recipient, you are hereby notified that any disclosure, copying, distribution or taking any action in reliance on the contents of this message or any accompanying document is strictly prohibited and is unlawful. The organization is not responsible for any damage caused by a virus or alteration of the e-mail by a third party or otherwise. The contents of this message may not necessarily represent the views or policies of Corvi