1. Messages
  2. [Zephyr-devel] Power Configuration of nrf52840

Re: [Zephyr-devel] Power Configuration of nrf52840

ashish.shukla@corvi.com <ashish.shukla@...>
 

Hi,

Yes, I'm working in high voltage mode.  VDDH = 3.6V

Then, I added following lines

NRF_POWER->DCDCEN0 = 0x01;  // Enabling DC/DC for stage REG0
NRF_POWER->DCDCEN = 0x01;   // Enabling DC/DC for stage REG1

Again, as you suggested

NRF_UICR->EXTSUPPLY = 0x01; 
NRF_UICR->REGOUT0 = 0x05;

After adding these lines at starting of main() function, It still measures 1.8V.


--
Warm regards,
Ashish Shukla
Jr. Embedded Engineer
Research & Development


Please consider the environment before printing this e-mail or its attachments.

Disclaimer: The information contained herein (including any accompanying documents) is confidential and is intended solely for the addressee(s). If you have erroneously received this message, please immediately delete it and notify the sender. Also, if you are not the intended recipient, you are hereby notified that any disclosure, copying, distribution or taking any action in reliance on the contents of this message or any accompanying document is strictly prohibited and is unlawful. The organization is not responsible for any damage caused by a virus or alteration of the e-mail by a third party or otherwise. The contents of this message may not necessarily represent the views or policies of Corvi


On Wed, Feb 7, 2018 at 4:16 PM, Puzdrowski, Andrzej <Andrzej.Puzdrowski@...> wrote:

Hi

So you must have supplied nRF52840 from VDDH pin – so it power regulator circuit works in high voltage mode.

 

Then internal regulator generate the GPIO output voltage:

You need to set UICR->REGOUT0 properly, 5 is proper value for select 3.3 V

 

For more info see nRF52840 OPS, especjali POWER chapter

 

Andrzej

 

From: zephyr-devel-bounces@lists.zephyrproject.org [mailto:zephyr-devel-bounces@lists.zephyrproject.org] On Behalf Of ashish.shukla@...
Sent: Wednesday, February 07, 2018 8:22 AM
To: zephyr-devel@lists.zephyrproject.org; zephyr-users@lists.zephyrproject.org
Subject: [Zephyr-devel] Power Configuration of nrf52840

 

Hello everyone !!!

I'm working with custom PCB of nrf52840. I need to set VDD voltage which is also GPIO high level voltage equals to 3.3V, otherwise it's 1.8V by default.


How can I configure this?

or

How can I access registers of nrf52840 in zephyr architecture?    

 

 

--

Warm regards,
Ashish Shukla

Jr. Embedded Engineer

Research & Development

 

Please consider the environment before printing this e-mail or its attachments.

 

Disclaimer: The information contained herein (including any accompanying documents) is confidential and is intended solely for the addressee(s). If you have erroneously received this message, please immediately delete it and notify the sender. Also, if you are not the intended recipient, you are hereby notified that any disclosure, copying, distribution or taking any action in reliance on the contents of this message or any accompanying document is strictly prohibited and is unlawful. The organization is not responsible for any damage caused by a virus or alteration of the e-mail by a third party or otherwise. The contents of this message may not necessarily represent the views or policies of Corvi

 
Join {users@lists.zephyrproject.org to automatically receive all group messages.