When I run the zephyr/samples/subsys/usb/mass example for board mimxrt1050_evk everything works fine except is only runs at normal USB Full speed 12M. I have tried to add "CONFIG_USB_DC_HAS_HS_SUPPORT

#usb

Hi, I am using nrf52840dk_nrf52840 for my project. In my current task I have enabled CDC_ACM to receive device certificated via USB and store it to internal flash using settings. During storage, when

#uart #usb

Hi! I'm currently trying to get USB on a STM32G0B0 running. While booting i get the following error on the Linux Workstation: [ 691.189913] usb 1-5.2: new full-speed USB device number 15 using xhci_hc

#usb

Hi, I am trying to figure out how to make a HCI USB Bluetooth host adapter with device management on a nRF52840 Dongle. My approach is to make a USB composite device consisting of the Bluetooth device

#nrf52480 #mcumgr #hci #usb

Hi all: Just wanted to see if anyone can confirm that we shouldn't expect USB Host mode support in 2.5.0, and that it's not in the works. I found an old issue from May 19th that seems to indicate that

#usb #otg

Hi, Zephyr open source controller does not support long range. The feature is under development by our contributors. The missing supported commands may be a bug, but on quick review I could find them

#ble #hci #usb

Hi to everyone: First post. I've a simple Zephyr RTOS program where I use USB CDC ACM to see the output of the console and also the printk output. Everything works fine, if I connect a terminal progra

#usb #nrf52840

I have the HCI USB project built and running on my nRF52840 DK board. It works if I talk to it via ubuntu running under VirtualBox on my Win 10 system, but not if I plug it into a Raspberry Pi, or my

#ble #driver #nrf52840 #usb

Hi, I am wondering if anyone has tried reading for a serial port using node-red Currently, I'm using putty to read messages sent from my device built with help from zephyr mesh demo, as I'm using the

#ble #bluetoothmesh #gpio #usb #bluetooth

Hi, Iam using nrf52840 DK as a BLE controller. So i compiled a hex file and loaded into it. There after when we power on am getting the bdaddr of the device as 00:00:00:00:00:00, But when i check the

#bluetooth #nrf52480 #usb #ble

I'm looking for information on supporting a #usb based wifi adapter, with or without off-loaded stack support? --tnx --tom

#usb

Hi guys, I have custom board. There was an error in my config with CONFIG_SYS_CLOCK_HW_CYCLES_PER_SEC parameter. I adjusted it to my PLL clock settings. Now everything works fine. Thanks for the feedb

#stm32 #usb

Hi, Do you use a custom board based on stm32f412 SoC? Does the sample application "samples/subsys/usb/cdc_acm" works on your board? Yannis

#stm32 #usb