Hello, I am using nRF52833 Soc with nRF Connect SDK v1.7.0 and SES (Nordic Edition) v5.6.0 (64-bit). I have two project configuration files prj_debug.conf and prj_release.conf I switch between the two

#nrf52

Hi Jason, Thank you for your reply. It was helpful. I created a new local Kconfig file in my project folder and added the following lines, menu "MyDevice Settings" config DEBUG_PORT_ACCESS bool "Allow

#nrf52832

Hello, I need help with Access Port Protection on nRF52833. I have added the line CONFIG_DEBUG_PORT_ACCESS=y in prj.conf file and now the project does not open in Segger Embedded Studio (SES). I am ge

#nrf52832

Hello, I am getting this error Error: nrf5340pdk_nrf5340_cpuapp.dts.pre.tmp:710.1-6 Label or path temp not found when I try to load a project in SES v5.34a (File > Open nRF Connect SDK Project ...). H

#nrf5340 #dts

Hello, I am using a third party chriptographic engine that provides a dedicated hardware accelerator for AES-128 encryption based algorithms. I am using this engine to encrypt and decrypt the data tra

#crypto

I need to keep track of the time elapsed since boot-up using the function k_uptime_get() but it is always returning zero (0). I am using an nRF5340PDK and Zephyr OS build v2.3.0-rc1-ncs1. The IDE used

#api

Hello, Can someone please tell how to read/write to GPIO pins (ports P0 and P1)? I am using zephyr and NRF Connect v1.30 Thank you. Kind regards Mohamed Belaroussi

#gpio

Hello, I am looking for some some nRF5340 example code that reads the nRF5340 die temperature using zephyr APIs. I've looked at previous posts but I could only find this one https://devzone.nordicsemi

#nrf5340

Hello, I need to communicate with an SPI device (Semtech LR1110) connected to the nordic SoC nRF5340 via its SPI peripheral. I have the driver source code but I am not sure about the steps I need to t

#driver