Ok, found the issue: It was do to pin mapping naming. I was assuming that the pinmaps in Arduino D5, D6, and so on, corresponded to a direct GPIO map, so D5->GPIO_5 and so on... and that's not true. A

#gpio #nrf52832

Hi, No MCUBoot. And yes, the board boots correctly and I can use GDB to debug. I can see the GPIO driver calls, the values that are set and so on. My prj.conf file is as simple as it can get: CONFIG_G

#gpio #nrf52832

Not sure if I'm going to have any help on this, but anyway: I've a standard NRF52832 module that has connected to pin 5 a red LED. If I flash the module (through JLink) with the Arduino framework, the

#gpio #nrf52832

I'm starting a simple project for testing the Zephyr port of the Loramac-node, but it's failing to compile. I've added the necessary prj.conf config lines: CONFIG_LORA=y CONFIG_HAS_SEMTECH_LORAMAC=y C

Hi to everyone: First post. I've a simple Zephyr RTOS program where I use USB CDC ACM to see the output of the console and also the printk output. Everything works fine, if I connect a terminal progra

#usb #nrf52840