Problem in I2C interfacing with nrf52840 <ashish.shukla@...>

Hello everyone !!!

I'm trying to interface an EEPROM with nrf52840 using I2C protocol.

For this, I used  .../samples/drivers/i2c_fujitsu_fram example, I'm able to read bytes from memory, but I can't write anything in memory. It's write_bytes() function doesn't seem to be working.

Did someone faced the same issue? and what needs to be done to fix this?

Warm regards,
Ashish Shukla
Jr. Embedded Engineer
Research & Development

Please consider the environment before printing this e-mail or its attachments.

Disclaimer: The information contained herein (including any accompanying documents) is confidential and is intended solely for the addressee(s). If you have erroneously received this message, please immediately delete it and notify the sender. Also, if you are not the intended recipient, you are hereby notified that any disclosure, copying, distribution or taking any action in reliance on the contents of this message or any accompanying document is strictly prohibited and is unlawful. The organization is not responsible for any damage caused by a virus or alteration of the e-mail by a third party or otherwise. The contents of this message may not necessarily represent the views or policies of Corvi