Topics

Reconnect to a provisioned node in Mesh BLE #bluetoothmesh #meshctl #ble


Uilter Witte
 

Hi,

I'm working with Zephyr Project to study and build light solutions using Mesh BLE.
 
To proof the concept I'm using the following setup:
- 2 boards of Nordic with nRF52832 model PCA10040;
- Raspberry Pi Zero W with Bluez 5.50;
 
It worked without problems.
 
I'm using Zephyr Kernel v1.13.0 and Zephyr SDK 0.9.5.
 
My first objective is been able to provisioning and control the nodes through linux using the bluez.
Today I can do that, but I'm experiencing some problems in the reconnection phase of the node when I fully power it off.
 
How can I reconnect the node through bluez and control it again?
I'm not find any tips on internet or something like that.
 
Thank very much to tips or advice.
 
Regards,
Uilter Witte


Uilter Witte
 

I discovered what I forgot to do.

The provisioner, in my case the RPI, lost the connection with the network.
When it happens you just need to execute the command:
[meshctl]# connect [net_idx] [dst]                           //Connect to mesh network or node on network

Where [net_idx] is the number of the network that want to connect, what in my case is 0.

Thanks.

Em seg, 19 de nov de 2018 às 11:32, Uilter Witte <uilter.witte@...> escreveu:

Hi,

I'm working with Zephyr Project to study and build light solutions using Mesh BLE.
 
To proof the concept I'm using the following setup:
- 2 boards of Nordic with nRF52832 model PCA10040;
- Raspberry Pi Zero W with Bluez 5.50;
 
It worked without problems.
 
I'm using Zephyr Kernel v1.13.0 and Zephyr SDK 0.9.5.
 
My first objective is been able to provisioning and control the nodes through linux using the bluez.
Today I can do that, but I'm experiencing some problems in the reconnection phase of the node when I fully power it off.
 
How can I reconnect the node through bluez and control it again?
I'm not find any tips on internet or something like that.
 
Thank very much to tips or advice.
 
Regards,
Uilter Witte



--
--
Uilter Witte