[Zephyr-devel] cy8ckit_062_wifi_bt_m0 board issue


Hi Jason,

Are you using P13-0, P13-1 ? See below:
The PSoC-6 has a weird connection with an onboard psoc programmer. It uses the same pins from the Arduino UART Connector.
To enable shields, uart was directioned to another port. You can enable any if you prefer.

It shows a board review example. It can be useful for you.

BTW, there is almost no support for this boards, currently.

&uart6 {
status = "okay";
current-speed = <115200>;
interrupt-parent = <&intmux_ch21>;
pinctrl-0 = <&p13_0_uart6_rx &p13_1_uart6_tx>;


Em ter., 21 de dez. de 2021 às 12:08, Chen, Jason via lists.zephyrproject.org <jason.chen=assaabloy.com@...> escreveu:

Hi all


I have downloaded the zephyr project completely, I plan to use the cy8ckit_062_wifi_bt_m0 board, I have built successfully, there is no error, but there is no log output in the corresponding development board. Has the cy8CKIT_062_wifi_bt_M0 board of zephyr been tested?


If your build executable has data output, can you send me the.HEX or.elf file?




Jason chen



Best regards,

Jason Chen

Firmware Lead - APAC Ecosystem Team

ASSA ABLOY (China) Investment Company Limited
Mobile: +86 15921614136

Email: jason.chen@...


Experience a safer and more open world